View Single Post
Old 04-25-2011, 09:03 PM   #11
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,165
iTrader: (27)
Quote:
Originally Posted by S.J.SLEEPER View Post
you should hear/fell 2 to 3 clicks when installing the converter.

you should also not be able to put your finger behind bell & converter, that will tell you its seated all the way.
Normally you will have 3/16" to 1/4" gap between flywheel mounting surface & torque converter mounting surface when trans is bolted tight. then pull converter lightly foward til touching, then install all tc bolts in by hand, than tighten to spec.
this. it sounds like the TC is not fully engaged.
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
BonzoHansen is offline   Reply With Quote