Quote:
Originally Posted by sweetbmxrider
I have a 2.73 rear 10 bolt out of an lt1. No brakes on it, just the lt1 mounts I believe.
|
FYI OP, the backing plates for your LS1 will bolt up to the LT1 rear and it will be good to go. The only issue I had when I bolted up the LT1 rear in my car was that the wheel studs are a little bit shorter than the stock LS1's and they can break easily.
I also found this for you:
http://cnj.craigslist.org/pts/2711589834.html .
Also, before you go buy a whole rear, pop the cover off and see what's wrong, it takes 10 minutes. It could just be a bad pinion bearing which means you would only need a new ring and pinion and pinion bearing.