Quote:
Originally Posted by zraffz
Same issues.
He was fair the first time he took the motor back to clean it up, although he didn't do a good job. I feel like he just cleaned off what was visible. Anyway, I am praying he is willing to work with me on this. All I ask of him is to hot tank the block again, remeasure the cylinders to make sure they aren't out of shape and buy/install cam bearings.
At this point I'd rather do the final hone, send the rotating assembly somewhere to get balanced/crank polished and assemble it myself.
|
He should pray you aren't going to burn his shop down. The ball is in your court- especially because there's hard evidence he did a bad job.