NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

ThoR294 · 07-22-2013, 01:47 PM

Let's try again...
Brandon's 96 WS6

Better Quality Image (Idk why my resize is so blurry. 640x480 I guess

)

I bought this car in 2006 just before I graduated Automotive Training Center. I have a lot of memories with his car, a few scares, lots of mustangs slaughtered, and fun times. I have had a rear u-joint explode and deploy my airbags, I had a lady run over the front end of my car in a parking lot with a jeep (she parked next to me, and said the white paint on my hood and black paint on her rear bumper was always there), a blown stage 2 clutch that put the car down for 2+ years thanks to unemployment, a wicked vibration that made me scared to drive the car (Pinion Angle Issue) and a tree falling on it from Sandy. The car is now FINALLY back on the road (after about a $2000 parts list: clutch, flywheel, opti, water pump, both window motors/regulators, LS1 front brakes, rear brakes, plug wires, A/C Compressor, fuel pump that died after i installed the clutch...)

Right now, I am planning on getting LT headers/Y-Pipe/Tune and a paint job to repair the damage that bitch Sandy did...

Mod list:
GMMG Catback, TPIS Air Foil, SPEC Stage 1 Clutch, Strut Tower Brace, BMR Subframe Connectors, BMR LCAs, Deleted TB Coolant, 3.73s, Koni 4/4s, Strano Springs, UMI Adj. Torque Arm, UMI Relocation X-member, UMI Adj. Panhard Bar, MGW Shifter, LS1 Front Brakes, BLS Headlights, Clear corners, 10 powerbass speakers and a 10" powerbass sub in a stealth box...

Sandy Damage

07-22-2013, 01:47 PM	#2
ThoR294 ^^^Lover of bad cars^^^ Meet Coordinator Join Date: Aug 2007 Location: Whitehouse Station Posts: 2,269 iTrader: (1)	Let's try again... Brandon's 96 WS6 Better Quality Image (Idk why my resize is so blurry. 640x480 I guess ) I bought this car in 2006 just before I graduated Automotive Training Center. I have a lot of memories with his car, a few scares, lots of mustangs slaughtered, and fun times. I have had a rear u-joint explode and deploy my airbags, I had a lady run over the front end of my car in a parking lot with a jeep (she parked next to me, and said the white paint on my hood and black paint on her rear bumper was always there), a blown stage 2 clutch that put the car down for 2+ years thanks to unemployment, a wicked vibration that made me scared to drive the car (Pinion Angle Issue) and a tree falling on it from Sandy. The car is now FINALLY back on the road (after about a $2000 parts list: clutch, flywheel, opti, water pump, both window motors/regulators, LS1 front brakes, rear brakes, plug wires, A/C Compressor, fuel pump that died after i installed the clutch...) Right now, I am planning on getting LT headers/Y-Pipe/Tune and a paint job to repair the damage that bitch Sandy did... Mod list: GMMG Catback, TPIS Air Foil, SPEC Stage 1 Clutch, Strut Tower Brace, BMR Subframe Connectors, BMR LCAs, Deleted TB Coolant, 3.73s, Koni 4/4s, Strano Springs, UMI Adj. Torque Arm, UMI Relocation X-member, UMI Adj. Panhard Bar, MGW Shifter, LS1 Front Brakes, BLS Headlights, Clear corners, 10 powerbass speakers and a 10" powerbass sub in a stealth box... Sandy Damage __________________ 1986 Honda VFR750 - 89.3HP to the wheel 2000 Trans Am M6 - Mods: Yes. 2018 Durango R/T - AFE Intake, JLT Catch Can, Stainless Works Catback, Vinyl Dodge Racing Stripes 2003 Toyota Matrix XRS M6 - Injen CAI, Borla Muffler, TC Wheels, Rear Sway Bar Last edited by ThoR294; 07-22-2013 at 06:32 PM.