Went over one of my headers with some red Scotch Brite to give them the brushed look. I am really digging the way they look now. After I get them in the car I'll go over them again to get all the fingerprints off.
I also got some of my plumbing figured out for the fuel lines. I am going to be able to mount the fuel pressure regulator on the back of the drivers side head, most of the lines will be hidden behind the engine, it should look good when I am finished.
Also I bought one of these tubing benders from Rigid. It was really easy to bend the stainless 3/8" tubing that I have been using. It was a little expensive, but I figure I am going to bend quite a bit more tubing and this one does 180 degree bends. I was using Phil's 3 size combination bender and it was a lot more difficult to bend the tubing since it has such short arms. I am glad I got this one. I have to bend up the line for the pressure feed and from the tee to the rail and I plan on making a hard tube for the PCV and the brake booster. I made the hard tube for the brake booster on the BBC and I liked the way it came out.
