|
Getting the Trans Am rolling!
I just booked my flight home in March from the 15-th to April 2 and hopefully weather permitting I'd like to get the Trans Am on the ground and moving under its own steam. I know the motor runs, and it didn't throw any codes which is a good thing, but it only ran for a minute and there is a small list of left over things that need to be done. I was hoping if I got the word out early, I'll be able to get a few hands free to swing by and help!
I have all the fluids I need as well, but In no particular order:
Tighten the master cylinder
Bleed the brakes
Re-Run the wiring harness
Add transmission fluid
Re-connect the steering knuckle
Wire the water pump
Replace radiator hoses & add new clamps
Bolt on hood
Intake assembly
Exhaust (Y-pipe & cat-back)
Strut Tower Brace
Rear lowering springs
I think thats all it needs to get back on the road before I take it in for an alignment. I'd like to at least be able to drive it around the block for the first time in a long time!
__________________
|