Quote:
Originally Posted by sweetbmxrider
What is currently on the rear? Do you have rubber hoses? The hard line and braided hoses are obviously the complete setup, if that is what you need then grab it. You will have to manipulate the hard lines to match the 12 bolt routing and overall length. 4th gen rears wider or narrower? I guess that is the only problem you'd run into. Could make your own lines if you are up for it.
|
4th gen rear is a little wider (.5"-1" on each side IIRC)
__________________
1983 camaro- Scrap
1988 camaro- Also scrap
'05 Silverado- You guessed it, scrap
1988 TRX 250R- Ported w/ high compression on 110 octane- Out 60' your LT1
Jersey Shore Street Car Takeover (JSSCT) Founder
Quote:
Originally Posted by LS1ow
and once i get PHB, what do i ajust it too?
|
Quote:
Originally Posted by Jersey Mike
Seven.
|
|