stall converter questions - NJFBOA - Home of New Jersey's Camaros and Firebirds

98tadriver · 07-02-2008, 05:44 PM

I might be selling a stall converter to a member on the boards here but before i do so, i need to know if its going to work.

will a stall converter that was on a 89' camaro w/ 700R4 work with this car? (below)

95 Camaro Z28 auto (4L60E)

are the splines and flywheel to tq converter bolt pattern the same? thanks in advance!

Tru2Chevy · 07-02-2008, 08:07 PM

AFAIK any 700R4 / 4L60 / 4L60e converter will swap from 87-97 transmissions. I think the LS1 4L60e uses a different converter.

I'm not 100% sure about this, but fairly confident.....

- Justin

Savage_Messiah · 07-03-2008, 12:59 PM

I'm not sure but would the lockup engageent be affected going from a non elec. to an elec. controlled trans?

GrandmasterCow · 07-03-2008, 02:02 PM

I think the LS1 trans uses a different length inputshaft than 700R4 and previous 4L60e. I forget if it's shorter or longer.

WildBillyT · 07-03-2008, 03:02 PM

Quote:

Originally Posted by GrandmasterCow

I think the LS1 trans uses a different length inputshaft than 700R4 and previous 4L60e. I forget if it's shorter or longer.

If it's anything like the T56's, then it's longer.

LTb1ow · 07-03-2008, 04:46 PM

Well it would be going in an LT1.