Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Event Forums > NJFBOA Events > East Coast F-Body Nationals > 2006 East Coast F-Body Nationals

Notices


 
 
Thread Tools
Old 01-21-2006, 05:20 PM   #1
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
Foot Brake Bracket Racing

General Requirements for ALL Foot Brake Classes:

General Rules
GM F-body Platform Vehicles Only
All vehicles must pass an NHRA safety inspection and must be properly equiped for the ET and MPH they will be running.
After passing tech inspection cars will be allowed to make test/practice runs. The number of runs will be determined by the schedule the day of the event, all cars will receive at least 2 passes, more if time permits.
Eliminations will be held on a .500 Sportsman Tree
Racing is Foot Brake Only. No Electronics(trans brakes, two steps, delay boxes or any other et controlling electronics are prohibated)

Suspension and Chassis:
"Stock" type suspension only.
Bolt on replacement supension components acceptable
Relocation of leaf springs in board to permit clearance of class legal tire permitted
Mini tubs permitted to clear class legal sized tire
No backhalved cars permitted
Welded in subframe connectors and rear lower control arm brackets are permitted.

Exhaust:
Any type of header system permitted.
All exhaust must pass through muffler(s) before exiting system

Body and Interior:
Vehicle must have a "Full" interior. Complete dash, Driver and passenger front seats(rear seats may be removed), inner doors, complete carpeting. Console may be removed, but area must be carpeted. No "tinned" interiors
Vehicles must also have appropriate running gear to represent a "street" car. Headlights, brake lights, turn signals, windshield wipers, factory glass(front, rear, and door).......etc.
Body work must appear to be production. Replacement panels made of lighter materials(fiberglass/carbon fiber) are acceptable
Cars are asked to be painted and presentable

Transmission:
Automotive type transmission required
Lenco type transmissions not permitted
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association

Last edited by NJSPEEDER; 01-21-2006 at 05:24 PM.
NJSPEEDER is offline  
Old 01-21-2006, 05:26 PM   #2
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
6cyl Bracket Class Specific Rules

6cyl Bracket Class Specific Rules

Engine and Power Adders:
Any I6 or V6 engine permitted
As much of any 1 type of power adder as you want permitted(twin turbo's, multi stage nitrous, twin supercharger permitted).
No combining of different power adder types.
Intercoolers, Aftercoolers, Alchy/Meth/Water injection permitted.

Tire:
Any brand of drive tire permitted
All types of street or racing construction tires permitted

Prizes and Awards: TBA
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 01-21-2006, 05:32 PM   #3
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
True Street Radial Class Specific Rules

Engine and Power Adders:
Any engine permitted
As much of any 1 type of power adder as you want permitted(twin turbo's, multi stage nitrous, twin supercharger permitted).
No combining of different power adder types.
Intercoolers, Aftercoolers, Alchy/Meth/Water injection permitted.

Tire:
Any brand of drive tire permitted
Drive tires must be of common radial construction. No Racing Construction tires permitted(M/T and BFG DR's not allowed)
No tire size limit
Tires must have a treadwear rating of 150 or higher.

Prizes and Awards: TBA
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 01-21-2006, 05:34 PM   #4
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
Drag Radial Bracket Class Specific Rules

Engine and Power Adders:
Any engine permitted
As much of any 1 type of power adder as you want permitted(twin turbo's, multi stage nitrous, twin supercharger permitted).
No combining of different power adder types.
Intercoolers, Aftercoolers, Alchy/Meth/Water injection permitted.

Tire:
Any brand of drive tire permitted
Class restricted to radial construction racing tire(BFG, M/T, Nitto......Drag Radials)
No restriction on drive tire size

Prizes and Awards: TBA
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 01-21-2006, 05:36 PM   #5
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
Slick/Cheater(D.O.T.) Slick Class Specific Rules

Engine and Power Adders:
Any engine permitted
As much of any 1 type of power adder as you want permitted(twin turbo's, multi stage nitrous, twin supercharger permitted).
No combining of different power adder types.
Intercoolers, Aftercoolers, Alchy/Meth/Water injection permitted.

Tire:
Any brand of drive tire permitted
No limits on drive tire size
Tire must be bias construction
DOT Approved Bias Construction and Full Slick Tires will compete together in this class

Prizes and Awards: TBA
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 03-19-2006, 06:14 PM   #6
GT Automotive
 
Join Date: Mar 2005
Posts: 14
iTrader: (0)
Just hope there's enough participation to warrant all these seperate classes. Do we really need 6 cyl, radial and DR classes? Why not combine them and get a few rounds in. No fun if there are 3 cars per class. What's the difference since it's bracket racing, I'd rather see a few rounds with some prizes going to 1/4 final then diluting the attendance.
GT Automotive is offline  
Old 03-19-2006, 08:06 PM   #7
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
all classes were evenly and fairly well subscribed last year when we used the same breakdown. we expect to see numbers in all the foot brake classes increase noticably for our second year.
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 07-20-2006, 03:23 PM   #8
kazman
 
kazman's Avatar
 
Join Date: Aug 2005
Posts: 218
iTrader: (0)
Tim, for the drag radial class, any restruction on the front tires? Do the front have to be radials? Are Hoosier drag radials legal? Hoosier say "drag radial" on the side and have DOT numbers. The have 2 groves for tread. I was allowed to run these on the 'vette at E-town for the EFI event (drag radial class). As far a wipers go. I just pulled the arms and blades off and still have all the hardware, motor , switch etc. Can I just throw the arms and blades in back of the car or will I be forced to duct tape them on? Everything else in the car is legal for the event, seats , carpet, door panels, even the rear seat. Thanks
__________________
'95 Pontiac Formula
Blue-Green Chameleon
LT1 Auto

'07 Ford Mustang GT Alloy Metallic
4.6 Auto, 3.73 gears, C&L CAI, Diablo 91 octane tune, drag radials, and a saftey loop. What else do I need for a 14 second bracket car?
kazman is offline  
Old 07-22-2006, 08:47 PM   #9
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
if the tires are radial construction, they are legal. i hope you are not refering to the QTP's though, those are bias ply construction. i thought the hossier radials had more than jsut two grooves around them? that sounds like the QTP tread patern.
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 07-23-2006, 03:39 PM   #10
kazman
 
kazman's Avatar
 
Join Date: Aug 2005
Posts: 218
iTrader: (0)
Quote:
Originally Posted by NJSPEEDER
if the tires are radial construction, they are legal. i hope you are not refering to the QTP's though, those are bias ply construction. i thought the hossier radials had more than jsut two grooves around them? that sounds like the QTP tread patern.
Tim, I run usually run QTP's on the bird. These are a new product from Hoosier. Drag radials with the same tread pattern. Not slicks, not bias. DOT drag radial. The are a very soft compound. Look like a cheater slick from 10 feet away. The do have dot and say drag radial.

https://www.hoosiertire.com/Drtire.htm
__________________
'95 Pontiac Formula
Blue-Green Chameleon
LT1 Auto

'07 Ford Mustang GT Alloy Metallic
4.6 Auto, 3.73 gears, C&L CAI, Diablo 91 octane tune, drag radials, and a saftey loop. What else do I need for a 14 second bracket car?
kazman is offline  
Old 07-23-2006, 03:42 PM   #11
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
nice lookin tires, they are radials and DOT approved, so they are class legal. enjoy
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 07-23-2006, 03:46 PM   #12
kazman
 
kazman's Avatar
 
Join Date: Aug 2005
Posts: 218
iTrader: (0)
Thanks, Tim
__________________
'95 Pontiac Formula
Blue-Green Chameleon
LT1 Auto

'07 Ford Mustang GT Alloy Metallic
4.6 Auto, 3.73 gears, C&L CAI, Diablo 91 octane tune, drag radials, and a saftey loop. What else do I need for a 14 second bracket car?

Last edited by kazman; 07-23-2006 at 03:48 PM.
kazman is offline  
Old 08-06-2006, 01:34 AM   #13
camaroracer1992
10 Second Club
 
camaroracer1992's Avatar
 
Join Date: Aug 2004
Location: Hatfield, PA
Posts: 1,292
iTrader: (7)
so whats the prizes gonna be??
__________________
_________________________

Procharged/intercooled 406 Shafirorff with FAST XFI
Sponsors:
Boccellas Performance http://www.boccellasperformance.com/
Spohn suspension
http://www.spohn.net/
camaroracer1992 is offline  
Old 08-06-2006, 10:53 AM   #14
NJSPEEDER
NJFBOA Co-Founder
 
NJSPEEDER's Avatar
 
Join Date: Jul 2004
Location: All up in your kool aid!
Posts: 12,235
iTrader: (10)
we are pretty much only gonna have trophies and some plaques this year. it was a rough year to persue sponsorship for a single event.
__________________
Tim - NJSPEEDER
Currently F-bodyless

New Jersey F-Body Owners Association
NJSPEEDER is offline  
Old 08-15-2006, 07:09 PM   #15
angin52
11 Second Club
 
angin52's Avatar
 
Join Date: May 2006
Location: oak ridge nj
Posts: 50
iTrader: (0)
Hi, my 74 meets all the foot brake rules except carpet and it has alum door panels. It still has power windows and back seats, how bout we throw in a little extra weight to compensate, plus I go 260 lbs, otherwise I got to run with the electronic boyz? 74 z-28 12.15 on hoosier drag radials. Thanks,Steve
angin52 is offline  
Old 08-15-2006, 07:55 PM   #16
Tru2Chevy
Co-Founder / Site Admin
 
Tru2Chevy's Avatar
 
Join Date: Jul 2004
Location: Ewing, NJ
Posts: 22,473
iTrader: (8)
Social Networks:

Sounds good enough for foot brake to me

- Justin
__________________
1999 Camry - Beigemobile DD
2002 Suburban - Wife's DD
2004 Grand Cherokee - Not running / Project / Selling?

Tru2Chevy is offline  
 

  NJFBOA - Home of New Jersey's Camaros and Firebirds > Event Forums > NJFBOA Events > East Coast F-Body Nationals > 2006 East Coast F-Body Nationals


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Sponsor List














All times are GMT -5. The time now is 10:54 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.