Anyone know where I can get a fitting for the 14x1.5 brake fitting or parts to build a fitting. I need to go from 14x1.5 Thread, Bubble flair,male to 1/8 npt female. I have tried a lot of places, and search the internet for hours with no luck. The one place that I found a fitting I bought and it is the right thread but not long enough and everywhere I go or call cant help. Here what I am connecting too.
Is there enough meat in the fitting to drill and tap it to 1/8npt on the inside? If so I know where to get unions for that size, so with a union and another 14mm fitting you could end up with a 1/8-27 female thread
Ok I looked at my car.
I assume you are installing an adjustable prop valve?
I used a union, another 14.5mm fitting with a short flared piece in it to make a seal, then drilled and tapped the fitting and installed a heavy wall steel 1/8 pipe nipple between the fitting and the prop vavle.
I know it sounds a tiny bit ghetto, but it the only 'bolt on' way to do thus I have ever found outside of a custom machined fitting. Its been on my car for probably 10 years now with no problems