![Reply](http://www.njfboa.org/forums/images/buttons/reply.gif) |
09-22-2013, 11:25 AM
|
#1
|
Join Date: Dec 2004
Location: manchester, NJ
Posts: 1,775
|
hvac guys help... heat for garage??
going to be looking into getting some kind of a heater in my garage seeing as my project is no where near done and the cold weather is on its way. My question is what would be the safest and most efficient way to heat my garage. By safest i mean that i will be working with chemicals such as paints, body fillers, primers thinners, etc.... and dont want a fire hazard. it is an over sized two car garage so its not to big. what would be the best type. keep in mind too that doing body work it would have be at least 60 plus degrees in there so the fillers and primers could dry correctly... thanks for any help cause im kind of lost with this stuff...
__________________
97 Firebird Formula - 383LT1
15 Subaru WRX - 2.0L-turbo
|
|
|
09-22-2013, 12:01 PM
|
#2
|
Mongo the Meet Coordinator
Join Date: May 2008
Posts: 16,899
|
Are you able to run a gas line to it or stuck with electric heaters?
__________________
Quote:
Originally Posted by KirkEvil
repo bigals turd gen and part it out to a loving home
|
|
|
|
09-22-2013, 02:06 PM
|
#3
|
Join Date: Dec 2004
Location: manchester, NJ
Posts: 1,775
|
well would rather not have to plumb anything but it could be done if price was right and set up was right. also willing to get somthing that runs off kerosene or somthing along those lines... if it were safe
__________________
97 Firebird Formula - 383LT1
15 Subaru WRX - 2.0L-turbo
|
|
|
09-22-2013, 03:51 PM
|
#4
|
Join Date: Sep 2008
Location: Hackettstown, NJ
Posts: 1,634
|
Anything kerosene will have open flame exposed to whatever vapors you're creating, so I don't know how safe that'd be.
__________________
1998 Z-28 - SLP lid - Ported TB - LS6 Intake - Dynatech SS headers/Catted Y - Magnaflow Exh - 3.42 - Yank SS3600 - UMI weld-in subframe connectors, Adj LCA, Adj PHB, Q1A TA - Bolt-in Relocation Brackets - Strano springs - Koni shocks - 17" C6Z06 wheels - 326HP/335ft-lbs - 12.35 @ 110.41
Quote:
Originally Posted by Blackbirdws6
I can appreciate a dream but this person needed some real friends.
|
|
|
|
09-22-2013, 05:21 PM
|
#5
|
Stalker
Join Date: Aug 2004
Posts: 12,077
|
the safest for working with chemicals would be hot water baseboard heater. anything else will be a fire hazard.
If an attached garage, you could possibly add a loop to an existing zone, otherwise run an additional zone, but both may require a furnace upgrade.
a commercial unit would be something to look into since they might have fire safe designs
I use a dual burner propane heater, but i warm up the garage prior to doing any paint work. then shut it all off and paint. I then let the temp slowly drop(good insulation) and when it gets really down or when i can, I open garage to vent it all, then reheat since the fumes have cleared.
Last edited by V; 09-22-2013 at 05:22 PM.
|
|
|
09-22-2013, 08:07 PM
|
#6
|
Join Date: Dec 2004
Location: manchester, NJ
Posts: 1,775
|
yea kind of knew that any open flame design would be no good.. and base board is out of question because my house is gas forced hot air and my garage is detached and a good ways from the house anyway. not looking to spend thousands of dollars either on a big set up. what about electric infared type heaters. we had them in tech school and remember them working decent...anybody use them at all? im thinking my choices are goin to be to get some type of hanging gas furnace that has fan and everything all as one unit and get that plumbed in from gas guy.. or those electric infared heaters... gas option is going to cost more but will obviously work better and probably be more efficient and cheaper as far as energy use... im not going to be painting most likely but will definitly be priming... primer overspray is very minimal so chance of vapor fire is probably slim to none but dont wanna take chances if there is better options out there
__________________
97 Firebird Formula - 383LT1
15 Subaru WRX - 2.0L-turbo
|
|
|
09-22-2013, 08:43 PM
|
#7
|
Admin.
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,149
|
is the garage insulated?
__________________
Vent Windows Forever!
The looser the waistband, the deeper the quicksand. Or so I have read.
Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.
Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
|
|
|
09-22-2013, 09:27 PM
|
#8
|
Lord of the rings / 10 Second Club / Meet Coordinator
Join Date: Aug 2004
Location: Millstone Township, NJ
Posts: 6,357
|
Electric infrared heating would work fine but you need enough coverage since they can be relatively "focused". I would recommend a good ventilation system for any method you go with to minimize your safety concerns. I'm doing a gas furnace for mine since my gas line runs through the garage.
__________________
97 T/A Ram Air Convt
Forever dyno queen / 777rwhp 662 rwtq @ 17lbs / 10.2 @ 140
'24 Corvette Z06
17 Sierra 2500HD Dmax
81 Turbo TA
|
|
|
09-23-2013, 05:57 AM
|
#9
|
Join Date: Dec 2004
Location: manchester, NJ
Posts: 1,775
|
yea brian your garage is attached to your house right? that would be ideal but is for me to run gas all the way to my garage is probably going to cost me. if i went with the infrared type id probably get like 2 of them rated at the square footage to try and cover more room because i know what you mean. and im not sure if its insulated cause it was sheet rocked before i moved in... the doors are cheapo and non insulated i know that...
__________________
97 Firebird Formula - 383LT1
15 Subaru WRX - 2.0L-turbo
|
|
|
09-23-2013, 06:32 AM
|
#10
|
Lord of the rings / 10 Second Club / Meet Coordinator
Join Date: Aug 2004
Location: Millstone Township, NJ
Posts: 6,357
|
Quote:
Originally Posted by transmaro93
yea brian your garage is attached to your house right? that would be ideal but is for me to run gas all the way to my garage is probably going to cost me. if i went with the infrared type id probably get like 2 of them rated at the square footage to try and cover more room because i know what you mean. and im not sure if its insulated cause it was sheet rocked before i moved in... the doors are cheapo and non insulated i know that...
|
Yes it's attached and I only mentioned it depending on your accessibility from the house to the garage. Infrared would be the best for a non insulated space.
__________________
97 T/A Ram Air Convt
Forever dyno queen / 777rwhp 662 rwtq @ 17lbs / 10.2 @ 140
'24 Corvette Z06
17 Sierra 2500HD Dmax
81 Turbo TA
|
|
|
09-23-2013, 07:43 PM
|
#11
|
Join Date: Dec 2004
Location: manchester, NJ
Posts: 1,775
|
yea thats what i was thinkning because a gas heater will be running all the time in a poor insulated space and would be running my gas bill up like crazy. hopfully i can find some good efficient infrared heaters that wont cost alot with the energy bill, but will heat everything good
__________________
97 Firebird Formula - 383LT1
15 Subaru WRX - 2.0L-turbo
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
|
|