Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Tech Forums > Electrical and Wiring

Notices


Reply
 
Thread Tools
Old 03-10-2019, 12:10 PM   #1
Tlehmanjr
 
Join Date: Aug 2018
Posts: 2
iTrader: (0)
Ac compressor

1983 z28. Originally 305 5 speed 4 barrel carb. Had, and I said had, cruise control and ac from factory. Someone did some outstanding wire cutting under the hood and to be frank I am amazed that it actually runs. ECM is gone under dash also. Air was removed and I have almost everything to re-install, but cannot for the life of me find the power wire for the compressor anywhere on what is left of the wiring harness. I have a ground wire cut at the cruise control that I guess went on the one end of plug. Most of the hvac wiring is intact. Looked on the drivers side and passenger side with no luck. Picture in shop manual shows it branching off behind the distributor. No luck there either. Have done wiring before, but by far not an expert on subject. Can anyone give a clue as to where to look or possibly rewire the compressor to make it work? I tried tracing the diagram from factory and cannot locate. Thanks in advance.
Tlehmanjr is offline   Reply With Quote
Old 03-11-2019, 01:28 PM   #2
unstable bob gable
American Road Warrior
 
unstable bob gable's Avatar
 
Join Date: Jul 2005
Location: Wastelands of NJ
Posts: 6,116
iTrader: (2)
Hate to say it, but this board is so dead that you'll be lucky to get any kind of response. I put in a word to a buddy of mine to take a peep and maybe he can help you. He's pretty handy with 3rd gens.
__________________
unstable bob gable: LEGENDARY LEGEND,
ICONIC ICON, AND AMERICAN BAD AZZ!!!

1991 Dodge Spirit R/T: Gran'pa lookin' 150+ mph turbo rocket.

2013 Dodge Avenger RT: Wastelands cruiser.

2008 Crown Vic Police Interceptor: 'Nuff said!

THE ONLY THING THAT SUCKS WORSE THEN IMPORTS ARE RICED OUT IMPORTS!!!
unstable bob gable is offline   Reply With Quote
Old 03-11-2019, 02:52 PM   #3
unstable bob gable
American Road Warrior
 
unstable bob gable's Avatar
 
Join Date: Jul 2005
Location: Wastelands of NJ
Posts: 6,116
iTrader: (2)
My buddy took a look and it"s above his paygrade. He suggested you check with 3rdgen.org
__________________
unstable bob gable: LEGENDARY LEGEND,
ICONIC ICON, AND AMERICAN BAD AZZ!!!

1991 Dodge Spirit R/T: Gran'pa lookin' 150+ mph turbo rocket.

2013 Dodge Avenger RT: Wastelands cruiser.

2008 Crown Vic Police Interceptor: 'Nuff said!

THE ONLY THING THAT SUCKS WORSE THEN IMPORTS ARE RICED OUT IMPORTS!!!
unstable bob gable is offline   Reply With Quote
Old 03-11-2019, 04:07 PM   #4
sweetbmxrider
Meet Coordinator
 
sweetbmxrider's Avatar
 
Join Date: Jan 2008
Location: brick/pt. pleasant beach
Posts: 19,341
iTrader: (12)


__________________
sweetbmxrider is offline   Reply With Quote
Old 03-11-2019, 04:42 PM   #5
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,152
iTrader: (27)
There are also links in this very sub forum to all 3rd Gen. Wiring diagrams.
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
BonzoHansen is offline   Reply With Quote
Old 03-12-2019, 01:07 PM   #6
Tlehmanjr
 
Join Date: Aug 2018
Posts: 2
iTrader: (0)
Thanks to all that posted. At this point I will take all and any help available. I was under the hood all day yesterday to no avail. It seems like 2 steps forward and 3 back. People that destroy cars like this should not be allowed to own them in the first place.
Tlehmanjr is offline   Reply With Quote
Reply

  NJFBOA - Home of New Jersey's Camaros and Firebirds > Tech Forums > Electrical and Wiring


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Sponsor List














All times are GMT -5. The time now is 02:26 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.