Removing Torque management - NJFBOA - Home of New Jersey's Camaros and Firebirds

FASTEDDIE Z · 10-09-2009, 04:52 PM

Can I or anybody on this board remove my torque management or do I have to get it "tuned " to remove it ? Will a hypertech p3 remove it ? I just want to get all I can out of it until I do the converter , LS6 intake and headers . THEN get a full tune . I only have minnor bolt ons right now . Magnaflow c/b , K&N and a SLP lid .

Whiplash Performance · 10-09-2009, 06:32 PM

Quote:

Originally Posted by Eddie D.

Can I or anybody on this board remove my torque management or do I have to get it "tuned " to remove it ? Will a hypertech p3 remove it ? I just want to get all I can out of it until I do the converter , LS6 intake and headers . THEN get a full tune . I only have minnor bolt ons right now . Magnaflow c/b , K&N and a SLP lid .

Most programmers will reduce the effect of torque management and not completely eliminate it. A regular tune by a good tuner is a lot better then any programmer. We could help you out with either way you want to go.

Jersey Mike · 10-11-2009, 12:53 AM

I got a dyno tune & my tuner eliminated my Torque Management system, per request.
The following week, the 10 bolt died.

Featherburner · 10-11-2009, 08:50 AM

Quote:

Originally Posted by Jersey Mike

I got a dyno tune & my tuner eliminated my Torque Management system, per request.
The following week, the 10 bolt died.

Probably no correlation between the 2. I mean it's a 10 bolt. LOL