Air/Fuel Ratio Gauge - NJFBOA - Home of New Jersey's Camaros and Firebirds

Primo131211 · 08-06-2006, 09:38 AM

Hey guys. Im having some troubles installing my new gauge. I already mounted the pod on the pillar but now need to wire it up. By looking at the instructions i know where the wires need to go but still need some help with this. Does anyone know where i can find pictures or maybe a step by step page? Personal knowledge would be cool too.

Thanks!, Dan

Primo131211 · 08-06-2006, 01:05 PM

just an update. and since i got no responses, there are two O2 sensors. does it matter which one i hook it up to?

NJSPEEDER · 08-06-2006, 01:12 PM

you can tap into the purple wire coming off either O2 sensor that is before the cat and it will work correctly.

Primo131211 · 08-06-2006, 01:30 PM

thanks so much tim! This was exactly the post i needed! Ill be sure to stop back if i hit any more roadblocks

deadtrend1 · 08-06-2006, 04:29 PM

Hook up power and ground, then connect it to the signal wire from one of your stock, narrow-band O2 sensors.

I didn't run to the o2 sensor, i ran to the back of the PCM instead:
Purple/white wire, PCM pin C20 for the drivers side pre-cat O2;
Purple wire, PCM pin C8 for the passenger side pre-cat O2.

89 Trans Am WS6 · 08-08-2006, 07:13 PM

I wouldnt hook up the wire at the sensor, your better off doing it at the computer.

I rigged mine into a SPDT toggle switch so i can switch back and forth between bank 1 and 2

foff667 · 08-10-2006, 01:25 PM

I believe casper makes an adapter so that you dont have to splice into your wiring harness. BTW those gauges arent worth crap.

deadtrend1 · 08-10-2006, 04:43 PM

Quote:

Originally Posted by foff667

I believe casper makes an adapter so that you dont have to splice into your wiring harness. BTW those gauges arent worth crap.

yea, they make a good light show .... thats about it....