I'm.....scared......

[sweetbmxrider]

Jasper is notorious for doing that too.

[Frosty]

Originally Posted by sweetbmxrider

Jasper is notorious for doing that too.

I've seen some scary stuff come out of Jasper, almost as scary as the car I posted here

[Tale128]

I just died alittle..

[mtnhopper1]

Originally Posted by WildBillyT

I owned a 350 that had been bored .030 over in one hole.

Scary stuff. Seems like a hack job to me. I used to rebuild engines for a chrysler shop. It was a turn & burn shop cranking out rebuilt K-car 2.2L and 2.5L (and the occasional mitsu 2.6) 4-bangers, but even they would never have never let me do this.

Originally Posted by Frosty

I've seen some scary stuff come out of Jasper, almost as scary as the car I posted here

Maybe they figure that the likelihood of a balancing issue causing a problem in a street car is so small that it doesn't justify boring 7 extra holes. On the other hand, if they are replacing pistons anyways, its just the machinist's labor cost.

It's a cheapskate, penny-pinching hack move if you ask me, especially for a company like Jasper that, presumably, has in-house machine shop.

Originally Posted by sweetbmxrider

I like that shift nob.

I just caught this. Is that an Xbox controller?

[WildBillyT]

Originally Posted by mtnhopper1

Scary stuff. Seems like a hack job to me. I used to rebuild engines for a chrysler shop. It was a turn & burn shop cranking out rebuilt K-car 2.2L and 2.5L (and the occasional mitsu 2.6) 4-bangers, but even they would never have never let me do this.

Yup. It never even ran though. I bought it extremely cheap (as in $25 for a "rebuilt" engine) that he could not get going. I kept the alternator and sold the rest of the crap as parts. Turns out the timing chain was installed way off.