|
09-10-2007, 10:23 PM
|
#1
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
i love stupid people.
Last edited by Slo86Bird; 09-10-2007 at 10:26 PM.
|
|
|
09-11-2007, 06:04 AM
|
#2
|
Join Date: Jul 2006
Location: unknown
Posts: 2,776
|
Make sure they take your other wheels off and put them back on right because they could be next.
__________________
2000 Pewter Trans am, M6, SLP Lid,LS6 intake,Kooks 1 7/8" Long tube header,Classic Chambered Powersticks, hurst,off road X-pipe, Strano springs & Koni's, Monster level 2 clutch, HPtuners wide band tuned and a homemade ram air box sealed off.
|
|
|
09-11-2007, 06:14 AM
|
#3
|
13 Second Club
Join Date: Aug 2007
Location: philly
Posts: 46
|
very nice, probably scared the cr@p out of you.
__________________
1 tank of nitrous $40
1 tank of gas $55
Men getting owned by a chick who sprays - Priceless
338 RWHP 412 RWT! V6
|
|
|
09-11-2007, 06:43 AM
|
#4
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
as i was drivin i heard like clunk clunk clunk clunk and i hit the gas and it cleared up.....let off and it clunked again...i stopped and looked around, saw nothing. on my way back, i went to turn and i turned right and it pulled/swayed left. so at thatn point i was like wtf. after like 1/4 mile i just feel a huge bump and hear metal to metal so i pulled over asap and thats what it was... 15 minute drive turns into 3 hours.
|
|
|
09-11-2007, 08:16 AM
|
#5
|
Join Date: Mar 2006
Location: HARMONY NJ
Posts: 37
|
If I were you I would replace the studs on any wheel that was loose they weaken from the rim rocking around and hitting them.. Have seen it many times were you tighten the lugs up and a few miles later the wheel falls off and all the studs are broke off! just giving you heads up.
|
|
|
09-11-2007, 11:03 AM
|
#6
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
i was gettin my post rear installed on thursday anyways so idk what imma do. should i fix this one for now or have it towed to the other place?
|
|
|
09-11-2007, 11:05 AM
|
#7
|
Join Date: Jan 2007
Posts: 5,623
|
say it caused damage to the rear and you need the rear and wheel replaced.
__________________
2000 Tahoe Z71 5.7
1982 Z28 Pacecar 305
1999 S10
|
|
|
09-11-2007, 11:08 AM
|
#8
|
The Mayor / 2009 Member of the Year / Moderator
Join Date: Jan 2005
Location: Northwest
Posts: 8,866
|
Was this on the way home form Chatterbox? that sucks man...
__________________
1995 Z28 Convertible A4 13.78 @ 100 (CAI, high flow cat, catback, 160 thermo, hypertech, Strano springs, Koni yellows, sway bars, 3 pt. UMI SFC)
2018 Sea Doo GTX - 3 cylinders and das boooooost
Quote:
Originally Posted by BonzoHansen
Is English your 2nd language? Did you graduate high school? Your posts make my head hurt.
|
Team FARM
|
|
|
09-11-2007, 11:10 AM
|
#9
|
Join Date: Jul 2007
Location: North Jersey
Posts: 237
|
Thats bogus dude. I always check everything when I get a car serviced. Once came home and had a puddle in the driveway cause they never tightend the oil filter. As for tires I have a hard time getting them off cause they always over tighten the lugs on me. Did the rim get messed up from the lugs ovaling the holes? Hopefully nothing else was damaged. Lucky it didn't bend your fender out too.
|
|
|
09-11-2007, 02:53 PM
|
#10
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
i talked to them today and they say they didnt take the wheels off...how did they adjust the parking brake then? the adjuster holes on the inside are welded shut...they want 400 to swap the rears now and 100 to fix whats done right now so imma just pay the 100 and get it home so i can drive it for now. i just dont understand what they r saying. it sounds like bs to me.
|
|
|
09-11-2007, 03:16 PM
|
#11
|
Join Date: Jul 2006
Location: unknown
Posts: 2,776
|
They must have taken the wheel off cause you didnt drive that much so must have been something cause from the shop. they dont need to take the wheels off but sounds hell like they did. Theres an adjuster inside the rear drum for the parking brake.
__________________
2000 Pewter Trans am, M6, SLP Lid,LS6 intake,Kooks 1 7/8" Long tube header,Classic Chambered Powersticks, hurst,off road X-pipe, Strano springs & Koni's, Monster level 2 clutch, HPtuners wide band tuned and a homemade ram air box sealed off.
|
|
|
09-11-2007, 04:32 PM
|
#12
|
Hot Liz, Cold Beer
Join Date: Aug 2004
Location: Ewing, NJ
Posts: 1,497
|
Better find a new place to get it serviced, or else do it yourself from now on. Heh, could have been worse I suppose, what if it had caused you an accident? You should get your money back all together.
__________________
*Creator of the esteemed "Buddy List" thread. (RIP)*
*Creator of the short-lived Ignore List Thread (RIP)*
1987 Pontiac Fiero GT- Stock 2.8 aluminum "boat anchor" Runs like a champ. Needs a chip now!
Also: 1974 Honda CB550/four. Ah, the OPEN-open road.
99 Saturn SW1. Flaunting a fender "blemish" (large gaping hole) thanks to a hit a run. Never caught the guy. Permanent Driveway Status at Justin's.
|
|
|
09-11-2007, 08:05 PM
|
#13
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
idk. i went there after adjusting it 5 times..it either hung up too much or didnt catch till it was straight up. but the adjustment cost 10 bucks and idk.
|
|
|
09-11-2007, 08:29 PM
|
#14
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
last pic i forgot to add. one snapped and 4 bent
Last edited by Slo86Bird; 09-11-2007 at 08:30 PM.
|
|
|
09-11-2007, 08:36 PM
|
#15
|
Join Date: Apr 2006
Location: Landing, NJ
Posts: 1,042
|
jesus man good thing it didnt happen when u where on 80 hope things works out for ya
__________________
87 Trans Am 5.7, Auto, posi disc rear, flowmaster muffler, all org car.
88 Iroc-Z TPI, Cammed 350, Vortex Heads, Magnaflow, T5, 4 Wheel Disc, 3.27 9 Bolt PBR.
91 Trans Am VertTPI 350. 700r4, K&N Air Cone, Ryven Muffler.
|
|
|
09-11-2007, 08:41 PM
|
#16
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
im glad it didnt happen on 80 cuz it prolly woulda been a whole lot worse. and id prolly have to walk down the highway lookin for the wheel. lol. been there done that and it sucks
|
|
|
09-11-2007, 09:48 PM
|
#17
|
Join Date: Nov 2005
Location: Edison
Posts: 7,856
|
Wait this has happened to you before? Maybe it wasn't their fault..
You know thats not a gta wheel in the pic right?
__________________
1984 Firebird
2000 Z28
2023 Tacoma
|
|
|
09-11-2007, 09:57 PM
|
#18
|
Banned
Join Date: Mar 2007
Location: coumbia. nj
Posts: 1,317
|
i believe its a bbs or enkei wheel. but yeh i knew...it happened on our yukon cuz my moms bf did the brakes and never tightened the lugnuts.....we were on 287 and the wheel said see yaaaaa and rolled like a mile down the highway and we walked n got it. had all 4 lanes blocked by cops so we could move the truck from in the fast lane to the other side onto the shoulder.....like 3 weeks ago me n my brother were driving my sister f150 and her spare tire holder broke n her spare tire rolled down 80 and we got that and now she keeps it in her bed lol
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
|
|