Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Community Forums > Lounge

Notices


Reply
 
Thread Tools
Old 01-23-2014, 08:29 AM   #1
LTb1ow
Mongo the Meet Coordinator
 
LTb1ow's Avatar
 
Join Date: May 2008
Posts: 16,938
iTrader: (8)
Bluetooth OBD Diagnostic

Been looking at easy ways to display ATF temps, IATs and perhaps a corrected speedo via GPS.

Does anyone have any experience with these things? Their cheap and simple enough, but not sure if they display all the PID or not?
__________________
Quote:
Originally Posted by KirkEvil View Post
repo bigals turd gen and part it out to a loving home
LTb1ow is offline   Reply With Quote
Old 01-23-2014, 09:03 AM   #2
PolarBear
Ebearnezer Scrooge/Power Member/Lips
 
PolarBear's Avatar
 
Join Date: May 2006
Location: Hamilton, Mercer county
Posts: 4,141
iTrader: (16)
I've actually looked into a few of them and I found mixed reviews and the reason I haven't bought one yet. I was looking at the one to work with "Torque" for the Android OS and most people say the PLX ones work the best, but are the most expensive. There are some in the $15-20 range and some say they work and some don't.

PLX on Amazon

Last edited by PolarBear; 01-23-2014 at 09:07 AM.
PolarBear is offline   Reply With Quote
Old 01-23-2014, 09:05 AM   #3
creeper
 
Join Date: May 2008
Posts: 817
iTrader: (3)
I have the ELM 327 bluetooth with the torque app, it's pretty simplistic but it works well for $12. The speedo is pretty close to actual on the highway, and you can set up a screen of whatever supported PID's you want. Did the car in question come with the trans temp sensor? I don't think you can add additional inputs and create your own PID like in hptuners
__________________

|2000 Trans Am|T56 swap|Bolt Ons| Suspension|
creeper is offline   Reply With Quote
Old 01-23-2014, 09:28 AM   #4
LTb1ow
Mongo the Meet Coordinator
 
LTb1ow's Avatar
 
Join Date: May 2008
Posts: 16,938
iTrader: (8)
The car PCM programmed tire height is not whats on the car, so I want to use a GPS speedo output for actual speed displayed etc.

I am fairly certain the '80e transmissions can display internal temps as the trucks they come in have ATF guages.

Basically not looking to spend a lot cause at that point I will just get an aeroforce gauge but figured this is an easy way to monitor things since the phone never leaves my side anyway. Or pick up an old phone and use for just the bluetooth/screen aspect.
__________________
Quote:
Originally Posted by KirkEvil View Post
repo bigals turd gen and part it out to a loving home
LTb1ow is offline   Reply With Quote
Old 01-23-2014, 09:45 AM   #5
PolarBear
Ebearnezer Scrooge/Power Member/Lips
 
PolarBear's Avatar
 
Join Date: May 2006
Location: Hamilton, Mercer county
Posts: 4,141
iTrader: (16)
But I thought that stuff kills your phone
PolarBear is offline   Reply With Quote
Old 01-23-2014, 09:48 AM   #6
LTb1ow
Mongo the Meet Coordinator
 
LTb1ow's Avatar
 
Join Date: May 2008
Posts: 16,938
iTrader: (8)
It does, gonna wire in a cigarette port at some point when the dash comes out.
__________________
Quote:
Originally Posted by KirkEvil View Post
repo bigals turd gen and part it out to a loving home
LTb1ow is offline   Reply With Quote
Old 01-24-2014, 04:35 PM   #7
redsoxsstink
 
Join Date: Dec 2009
Location: milltown
Posts: 1,497
iTrader: (2)
Social Networks:

Quote:
Originally Posted by creeper View Post
I have the ELM 327 bluetooth with the torque app, it's pretty simplistic but it works well for $12. The speedo is pretty close to actual on the highway, and you can set up a screen of whatever supported PID's you want. Did the car in question come with the trans temp sensor? I don't think you can add additional inputs and create your own PID like in hptuners
thats what i use. its a little slow some monitors with the blue tooth so fuel trims and O2 readings are basically worthless, eventually ill buy a cable. i mainly use it for scanning/clearing codes. i know some diesels it is not compatible with so check the app first.
__________________
2002 Camaro Sunset Orange Mettalic, V6, 5spd, bilstein HD shocks and struts, eibach pro lowering kit, eibach f/r sway bars, lakewood PHB, UMI 2 point subframe connectors, energy suspensions poly master bushing kit
daily econobox and first car

1986 IROC-Z, T56, MGW shifter, Heads, Cam, Holley Stealth Ram 350, t-top, tubular LCA with relo brackets, adjustable PHB, belltech sway bars, ground control weight jacks, SLP mid length headers, 3in w/borla XR1, RIP 3 10 bolts, 12.7 @ 109 so far.. atleast its faster than stock SOLD

1971 Camaro LS3/T56/9in, cam only and still carbed, RIP 2 10 bolts, 11.62@121

03 Blazer 2 door - salt sponge
redsoxsstink is offline   Reply With Quote
Old 01-24-2014, 06:22 PM   #8
LTb1ow
Mongo the Meet Coordinator
 
LTb1ow's Avatar
 
Join Date: May 2008
Posts: 16,938
iTrader: (8)
This is for camaro, diesel has a nice edge cts
__________________
Quote:
Originally Posted by KirkEvil View Post
repo bigals turd gen and part it out to a loving home
LTb1ow is offline   Reply With Quote
Reply

  NJFBOA - Home of New Jersey's Camaros and Firebirds > Community Forums > Lounge


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Sponsor List














All times are GMT -5. The time now is 12:03 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.